I have done a dozen holes in glass with diamond holesaws, I guess I have to go and get some different ones for the Plexi...CRAP!!
ZENNZZO's duce duce five...
- Thread starter zennzzo
- Start date
How long is this?LowCel;2932697; said:It uses 2" threaded input and 1.5" threaded output. I put a ball valve union before and after it so I can easily remove it.
Make sure you put a piece of foam under it. Also, if you have access to flexible pvc put a piece on the input and output to get rid of the little bit of "hum" that it makes
Stand...DONE
wet/dry...started to fit the plumbing...
Working on fabing the switch panel and wiring.
Got the DART overflow from Glass-Holes.com today along with the correct size bulkheads...
the DiAmond hole saw works fine on acrylic, dry even...
PhullTank57 came by today to lend me a hand with the stand...Props Bro...
wet/dry...started to fit the plumbing...
Working on fabing the switch panel and wiring.
Got the DART overflow from Glass-Holes.com today along with the correct size bulkheads...
the DiAmond hole saw works fine on acrylic, dry even...
PhullTank57 came by today to lend me a hand with the stand...Props Bro...
No sweat, bro! It's gettin there... and it's lookin' good!PhullTank57 came by today to lend me a hand with the stand...Props Bro...
That's possible, I'll be going there for a graduation of my neice soon...She's an RN now...jdmkid;2939881; said:
Sometimes its just having a helping hand that makes things go so much smoother...He's one of the good guys...Yanbbrox;2940002; said:
I figured somebody would say Dam Zennz, that's a huge W/D for a 225g...PhullTank57;2939745; said:No sweat, bro! It's gettin there... and it's lookin' good!
and I could tell them it was a 90g W/D with 8 cu ft of Bio Chamber...
