to make 2 racks that each hold 10 poles you will need,
1-10'x2" pvc cut into 6" pieces
1-8'x6"x1" piece of wood cut in half or however long you want.
drill a hole in the center of each pipe bigger then your screw head.
"big hole only on one side of the pipe."
then put a screw through it and attach the pvc to the wood.
you can put it on the ceiling like i did or the wall.
before you build,
line up all your poles how you want them and measure the distance between them.
then make the spacing of the pipes the same.
i have some close,some far.
i beefed it up a bit over my big reels cus there heavy.
other then that,thats about it.
1-10'x2" pvc cut into 6" pieces
1-8'x6"x1" piece of wood cut in half or however long you want.
drill a hole in the center of each pipe bigger then your screw head.
"big hole only on one side of the pipe."
then put a screw through it and attach the pvc to the wood.
you can put it on the ceiling like i did or the wall.
before you build,
line up all your poles how you want them and measure the distance between them.
then make the spacing of the pipes the same.
i have some close,some far.
i beefed it up a bit over my big reels cus there heavy.
other then that,thats about it.
