start to my diy 480 gallon timber pond (not finished)
- Thread starter midnight
- Start date
its an update lol
these are the filter and pond bottoms.im doubling them up if i didnt say that before.
i used thompson water seal on the edges and some white paint i had for the middle.
reason is i dont want to see white paint,and it would cost alot for enough sealer to do it all.
will be doing more in the next few days so keep an eye out.
"going to try to finish soon,going to miami soon and might need room"
these are the filter and pond bottoms.im doubling them up if i didnt say that before.
i used thompson water seal on the edges and some white paint i had for the middle.
reason is i dont want to see white paint,and it would cost alot for enough sealer to do it all.
will be doing more in the next few days so keep an eye out.
"going to try to finish soon,going to miami soon and might need room"
greedy greedy people
give a little,and want more
will put on the bottoms tomorrow and do the sides.
then this weekend start adding styrofoam.
then im stuck still on the filter design
I'm laying styrofoam all in my filter box too then liner, the concreet didnt turn out very smooth and i dont want it wearing through my expensive liner...
well im bricking it in with cinder blocks, its ontop of the hill, i poured a 4' foundation and im useing 10" blocks for the walls fo the hill doesnt cave in on it, then im useing 2" conuet tubeing to make a frame that allows a space at the bottom and then plastic lath ontop of that for seperation, then ontop of that im putting home made pot scrubbers, then bags of lava rocks then the plastic lath then filter wool, the polyester fine filter mesh stuff for oplighing the water then the lath again helt together with the tubeing.... its interior is going to be 4'X4'X5' tall then this will spill out onto the waterfall...
let me draw a picture....
ok here is the pic...
let me draw a picture....
ok here is the pic...
