So I'm planning on building a plywood tank out of an old 40 breeder I have laying around, but I'm not sure if the glass will be able to hold up to the job
The approximate dimensions will be 78"x20"x36"
The glass from the breeder is 1/4 Inch
the front and back panels of the 40 would then become 1 panel divided by a wood brace in the middle. So is that even remotely doable or is the brace or glass just gonna fail catastrophically on me
Thanks Aaron
The approximate dimensions will be 78"x20"x36"
The glass from the breeder is 1/4 Inch
the front and back panels of the 40 would then become 1 panel divided by a wood brace in the middle. So is that even remotely doable or is the brace or glass just gonna fail catastrophically on me
Thanks Aaron