building a 1000 gal concrete block monster tank

Well, since I have the first and most important part of the tank, I figured I'd start this thread. I've been snooping around here for a while now asking questions, and thanks to all those who answered and helped. Below is the glass and the final design. If all goes well, I'll get the concrete, CMU's and framing next weekend. I have 10 days off over Christmas and I was hoping to get pretty far with it during that time.

The glass guy said he's not going to do anything with the other pieces, and if I want them he'll deliver them for me. They're bigger than this piece. I think they're 110"x39.5"x1"thck and 111"x39.5"x1"thck. They weight almost 300 lbs. It's 2 pieces of 1/2" laminated. I think it gives me some redundancy. If one piece fails, there's a membrane and another piece to back it up. So a failure wouldn't result in a catastrophy. Only thing is, it's tinted. Oh well. It's free right?

I'll post more once I get the block.



here's the design:

I'm torn. The purpose is for a silver aro comm and I wanted to do discus and aros. I've seen them together before, and it should work if the aros grow up with the disucs. BUT. I've got a clown knife that I want in there, which destroys the amazon theme, so then it's up in the air. Then there's an rtc I want to get off another mfk member, so I'll have just a mix I think.

Maybe 3 silver aros, ck and an rtc. Might be it, might not. That's still a ways off.

Sexy design there! Where is the filtration?

Click to expand...

I'm interested in the filtration plan as well. I also vote for a SA community, but it will be impressive either way. Were you planning on building a cover or something to keep the aros from jumping? Good luck with everything.

Click to expand...

that sketch is only partial. I didn't go all the way with it yet. The filtration is a 100 gal overhead W/D fed by 2 500gph pumps (1 in each corner) and another 500gph for circulation via UGJ's. It'll also have a continuous water exchanger. I'm building the inline R/O to feed the tank using parts. It will have tight fitting acrylic covers.

I'll post another design pic with more details later.